| Step | | Procedure & Parts & Tools |
| 1 |
|
EMPTY THE TANK. LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 2 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 3 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE. LIFT UP ON TANK TO OPEN MACHINE.
|
| 4 |
|
LOOSEN THE 2 BOLTS (1 ON EACH CLAMP) ON THE JUMPER CABLE AND PULL TO REMOVE IT FROM THE BATTERY POSTS. LOOSEN THE NUT HOLDING THE NEGATIVE CABLE END TO THE POST.
| Wrench-metric 10mm |
|
|
| 5 |
|
REMOVE THE NEGATIVE CABLE FROM THE POST
|
| 6 |
|
LOOSEN THE NUT HOLDING THE POSITIVE CABLE END TO THE POST.
| Wrench-metric 13mm |
|
|
| 7 |
|
REMOVE THE POSITIVE CABLE FROM THE POST
|
| 8 |
|
REVERSE STEPS 4 THRU 7 TO INSTALL NEW BATTERIES AND REINSTALL THE BATTERY CABLES. THIS DIAGRAM SHOWS THE CORRECT WAY TO CONNECT THE BATTERY CABLES.
|